[R146]Refinishing Hardwood Floor Cost

Now that you have decided to give that old hardwood floor a new shine it is time to plan the job properly and in advance. The first and most obvious thing to do when planning is to decide when to do the job. Once you have that, then you make a list of everything you will need. Some things you will want on this list are: A Sander, a box of trash bags, masking tape, a couple of plastic sheets or a role of plastic, vacuum, dust pan and broom, a clear floor sealer, floor stain if you want to change the coloring, pieces of sample wood that match your floor sanded down, a pry bar for any baseboards you are going to replace, face mask and gloves to help keep you safe. Also, do not forget hardwood floor cleaner that does not have any wax added to it. Making sure you have these items will make refinishing your Hardwood Floors an easier task.

When Refinishing Hardwood Floors, the first thing you have to do is begin removing all the furniture, wall hangings, window treatments or curtains, and any closets connecting to the floor you are working on have to be emptied out as well. Use the floor cleaner and a vacuum to get the floor ready for sanding. Now you want to cover any light fixtures with the trash bags mentioned earlier using the masking tape to help secure the bags. Cover any electrical outlets in the room with the tape as well. When it comes time to sand, you want to plug the sander into an extension cord plugged in an outlet outside of the room.

Now is the time to remove the baseboards if you are going to replace them. Once everything possible is covered and the room and any closets or cubbyholes emptied, it is time to block the room off from the rest of the house using the plastic sheets. You will want to use the masking tape to keep the plastic sheets closed on any doorway you will not be using. Be generous with the plastic sheets and leave a little room on each side, the top and bottom of the doorway, this will help in keeping the mess inside the room. Finally, open a window and put a fan in it blowing outwards. This helps keep the room healthy for you to work in. I recommend a box fan, as they are easier to clean and fit in most windows. Doing this makes Refinishing Hardwood Floors a safer project.

When you sand be sure you move quickly and smoothly while using the machine. If the sander is allowed to sit in one spot it can cause serious damage to the floor. Start out with a lower sander setting to help even the floor, and work up to the highest setting such as 120 to finish the sanding process. This helps with getting the floor even and smooth. As you sand you should see the grains returning in the wood.

A drum sander is recommended by many to do the sanding process, but be forewarned though it is very efficient and does the job quickly it can damage the floor if not properly operated. Always tilt the sander back until it reaches the desired speed before placing it on the floor. This makes sure you start out with an even sanding. Start on plywood or some other wood you will not be using so you can get used to the feel of the machine. Once you can control the beast start in the middle of the room. After you have finished sanding each time, vacuum the floor before starting again and at the end. Follow up with a dry clothe.

It is now time to stain and seal or just seal your new floor. Remember to check the drying times on each making sure you do not mess up all your hard work. Congratulations, you just refinished your Hardwood Floors.