To begin with, you will most likely want to use a paint stripper rather than hours of sanding. There are many commercial paint strippers on the market. One thing you must bear in mind is these are chemicals, and most certainly must be treated with respect.



You must put all of the safety precautions in place before you begin to work. First of all, you will want to work in a well ventilated area. The fumes of some of these paint strippers can be pretty strong, and dangerous to breathe for any period of time. Perhaps you may want to consider wearing a mask that is applicable for fumes. In addition don't bypass the safety goggles, If any of the solution were to splash in your eyes it could cause blindness.

Although there are many commercial strippers on the market, they all will have their own individual instructions on how to use it. Be sure and read the directions carefully before starting.

Ok so now you are ready to start. If possible, remove the body panel so it will be easier to work with. Put it on a stand if you have one and make sure the floor area is protected in case of drips. Now apply the stripper liberally with a brush unless it came with an applicator.

Once you have applied the stripper cover the piece with plastic. This will help to contain the fumes. In addition, it will help the stripper to work faster. Leave it this way for about 20 minutes.

Now remove the plastic and discard carefully. With a putty knife or a scrape start to remove the paint. Once you have scraped off all of the paint you can, rinse the piece with cool water. Be sure to wear you gloves. The cool water helps to neutralize the paint remover.

Once you have reached this point you need to assess the piece. If there isn't too much paint still there you may want to sand the remainder off. On the other hand, if there is a fair amount still to be removed you may want to re strip it again. Either way you want to be sure, all of the paint has been removed. It wouldn't hurt to give it a light sanding once you are finished with the stripper.

We have given you the basic steps here on how to work with strippers. One thing you must remember though is to follow the instructions exactly as they are outlined on the product. If you are not sure what you should use, then check with the store where you are buying the product. There may be various types that are used for specific jobs. You want to be sure and get the one that is best for you. Once you have completed the job, make sure everything is disposed of properly.