Seeing as how the kitchen and the bathroom are the two rooms that can add or subtract the most value from your home when you go to sell it, it would make quite a bit of sense to keep these two rooms in the best condition possible. These two rooms, however, are also subject to some of the most serious problems a homeowner can face: water damage and mold contamination, which tend to go hand in hand.
Keeping the shower and bath tub cleaned regularly of mildew (another word for mold) is a good idea to keep it in good condition.
Water damage occurs when water comes into contact with your floor or anything else in your home and is not cleaned up properly. It can cause floors to buckle and cause what is called "cupping" if you try to dry it out too fast, so cleaning up water spilled on hardwood floors (or in a home that has flooded) can be pretty tricky. Since mold likes to live wherever water damaged items are and wherever there is moisture, where there is water damage, mold usually follows on some level or another.
Water damage can also result from simply not having a vent installed in the bathroom or kitchen to allow the steam from bathing or cooking to escape the room. If not directed to the outside of the house through one of these vents, the steam will float up to the ceiling and soak it. Mold eventually starts to grow in these places and you will have to replace the drywall. Even if mold does not start to grow, you will probably have to replace the drywall eventually, anyway, because the paper on the front of the drywall will start to separate and sag. This is not dangerous, but it is unsightly.
Water damage also occurs when you allow a toilet or bath tub to overflow and you do not clean up the water sufficiently. If you have a vinyl or tile floor in the bathroom, this is a good thing. This creates a barrier between the water and the flood underneath, since the tile or laminate should not absorb much, if any, water. If you have carpet in your bathroom, this is a bad thing. Water will be absorbed by the carpet, the padding underneath, and depending on the amount of water on the floor, the base of the floor underneath will also be soaked. Mold will eventually start to grow if you do not make sure and get as much of the water up as possible.
In the kitchen, water damage and mold growth can be prevented by keeping a check on the plumbing going to your dishwasher and your sink. Having a vinyl and not a hardwood floor in your kitchen is the best thing, but spills need to be cleaned up as quickly as possible.
Mold In A Home
Mold in the house can end up looking pretty nasty, but do you really know how easy it is to prevent this from happening to your home? Mold can get any and everywhere there is air and moisture, so you can imagine how well mold will set up in your kitchen, bathroom, and laundry room; however, there are many ways that you can keep it from taking root in any area of your home, not just these. Here are a few tips to help you stop mold growth before it starts.
Check out the humidity level in each room of your home. Mold loves humidity and warmth, so any room that steam might build up in needs to be properly ventilated. This means the bathroom, kitchen, laundry room, and your basement, since it is underground and not likely to have a lot of ventilation by its nature. You want to make sure that exhaust vents are installed in each of these rooms. Additionally, if you use the basement as a laundry room, you want an exhaust fan installed here and you want to make sure the dryer is vented properly to the outside of the house.
Any water spills in the house need to be cleaned up immediately, especially if you have carpet or hardwood where the liquid was spilled. The bathroom, kitchen, and laundry room in your home should always have a hard surface as flooring such as tile, but never hardwood or carpet, since these are porous and will soak up water very easily. Carpet all by itself is a hot bed for mold spores, especially if you do not use a premium quality vacuum cleaner.
Any dirty clothes hamper in the house should be cleaned out regularly, especially if it contains wet items. In fact, it is typically best to wash wet items immediately so you do not forget that they are in the clothes hamper. Once one piece of wet clothing starts to get moldy, it will spread to the rest of the clothing in the hamper and you will have to wash all of it twice to get rid of the mold and the smell. You never want to wash mildewed rags or anything else with other clothing that is not mildewed, because it will just transfer the stink to the other clothing. For the sake of simplicity, wash wet items as soon as you can or at least keep them separated from the dry dirty clothes.
Both Jim Corkern & Rachel Yoshida are contributors for EditorialToday. The above articles have been edited for relevancy and timeliness. All write-ups, reviews, tips and guides published by EditorialToday.com and its partners or affiliates are for informational purposes only. They should not be used for any legal or any other type of advice. We do not endorse any author, contributor, writer or article posted by our team.
Jim Corkern has sinced written about articles on various topics from Home, Health and Guide Guitar. Jim Corkern is a writer and promoter of quality companies and. Jim Corkern's top article generates over 823000 views. to your Favourites.
Rachel Yoshida has sinced written about articles on various topics from Home, Finances and Education. Rachel Yoshida is a writer of many topics, visit some of her sites, like and. Rachel Yoshida's top article generates over 550000 views. to your Favourites.
Build A Gaming System And one more thing invest in some rechargeable batteries in order to keep those wireless remote controls at peak performance!