Radiant heating system is the most convenient, comfortable, healthy solution to stay away from all atmospheric problems. Radiant Heat is clean and energy efficient. Together these benefits of radiant heat make it an ideal solution for any new construction or remodeling project. If you want to warm up your bathroom floors, basement or entire home or office pex supply becomes your center for designing and purchasing a radiant heat system that will meet your needs.



Radiant heat will add luxury and comfort to any part of your home or business. The feeling of comfort is caused by a combination of air temperature and radiant energy that equals the body's energy needs. When you receive a greater amount of radiant energy, you will be equally comfortable at a lower air temperature.

Wirsbo Radiant heating controls the rate at which a body loses heat by turning large surface areas (floors, walls, ceilings) into large, low-temperature radiators. These surfaces surround a person with warmth.

When a radiant heat system is switched on, energy is forced through a conductive material to create resistance or heat. Majority of the time an electronic line-voltage system is used. This system uses a special thermostat that has an integrated GFCI breaker for safety.

Dry radiant floor systems allow even heating throughout the entire floor. The heat radiates from the floor and warms objects near the floor as opposed to forced hot air that tends to rise to the ceiling. Radiant floor heats while reduces dust, draft, and noise problems associated with forced air systems. They can be more aesthetically pleasing than other forms of heating because there are no heat registers or radiators to obstruct interior designs. Manufacturers claim radiant floor heating saves 20 to 40 percent on monthly heating bills as compared to the other heating appliances.

Mostly the radiant heat panels are attracted to the sub floor using approximately 10 screws per panel. Manufacturer recommendations include screwing and fastening adhesive when installing the panel. An electrometric bonding material is placed in the grooves prior to tube installation. The tube is pressed into the groove flush with the surface of the panel. Though the installation does not take much time but involves quite techniques hence the installation is done by specialists.