Once the drywall is installed and screwed to the wall, it is going to need some tape and compound. This is a very big step as it is the final step in the way that your drywall looks. You must make sure that you are applying the mud or compound the right way to your walls to ensure that it looks great.

There are three steps to know about how to mud drywall.

1. know what tools you need and what type of compound. Being prepared is one thing that you have to make sure you are doing. you need to be sure that you are familiar with the items that you have to have.

joint compound will come in two ways, powder and pre mixed. They are going to be different textures. Taping compound is coarse and needs to be used for the initial tape. Topping compound is thin and smooth than regular taping compound. It should be used for finishing.

when applying mud you should use tape knives. These tools will come in different sizes and you should always use on that is a little longer than the first one for each layer that you do.

You want to be certain that all of your screws are sunk in deep. You do not want any protruding out so that you are not hitting them with your knife. You should go back and sink your screws in a little further if they are not in far enough.

2. you should follow procedure. When you are mudding drywall it is going to be a 4 step and four day project. You will want to let it dry for at least twenty four hours.

You can start with a tape layer. You should apply compound and then place paper in all the joints and the make it smooth with a little compound. You will also need to cover up all the nail and screws with compound. You should always make sure that your finish look is completely smooth and looking good.

You will want to apply two layers of compound that will smooth out the surface for you. you will want to use a good tape knife that is one or two inches longer than the one you used before. For the second and the third you will need to use a tape knife that is about seven inches to a foot in length.

You should try and put the compound on the joint and then smooth It with different strokes.

It may be hard to apply this compound. You will want to apply the mud in different variations of thickness. You need to apply pressure in different spots. When you are ding the side strokes you will want to put more pressure on the outer part of the knife. There are different procedures for smoothing and you will need to learn the right way for each method you are doing.

The finish coat is last of course. this is where you need to make sure that it looks good and is smooth.

3. have some patience on your side

when you are mudding you want to be consistent and take your time. You may want to get it done fast but you have to follow with the stages. You cannot rush the mud to dry. You have to wait and leave the enough drying time in between. This can be messy but it is something that has to be done to make the drywall come out right.