For a homeowner there is nothing more unsightly then mold. Even worse, still, is mold growing on your carpet. The first thing one usually decides to do upon discovering mold is to have it thoroughly cleaned. However, this can be far more difficult than it actually sounds. One of the biggest problems you can face may be that the mold isn't simply on your carpet.

It may also be on the padding beneath the carpet, and this could just cause even more damage than the original carpet. And if this is the case, the whole carpet should be removed. The padding should also be removed and thrown away.

Fortunately, removing carpet is a relatively simple task that can be achieved by someone who has never worked with carpet in their life. All the process takes is a little bit of common sense, and perhaps some patience.

The first thing you should do when removing the carpet is to take up the moldings that go all around the floor and to begin to take the doors from off of the hinges.

The only real purpose behind taking the doors off of the hinges is to create more space for you to work with as you take the old carpet out of the floor and put the new carpet in its place. It is probably a good idea to employ the use of a utility knife to cut the carpet up into strips.

Cutting the carpet will make the task of taking the carpet out much easier. However, when using the knife, it is very important to be careful, as you might have a hardwood floor underneath and it would be a tragedy to cut it.

You should always start at one end of the room and to pull the carpet from off of the tackless strips and to roll it up neatly. You can install new tackless strips later on if you make the decision to put a new carpet in later.

You should install them around the perimeter of the room you're working in, but make sure that you do not put them in front of any doorways. There needs to also be at least one half inch of space between the stips and the wall. The tack points should be facing the wall.

You should check the floor underneath for mold damage. It may be refinished if damage is found.

You won't have to reinstall carpet where the old carpet had been, but only depending on the condition of the floor.