The major components of the treadmill that require special attention are the deck and the belt. If the belt is not properly taken cared of, the deck's mechanical operation will also get affected.



Maintain your treadmill belt with lubricants especially if you run on it everyday. You will know if your belt needs replacement if you notice these items.

- When your belt has curls on its edges.

- When the speed slows down the moment you step on the deck.

- When obvious grooves appear on your treadmill belt.

Generally if the walking surface area of your belt for treadmill looks worn out, you may need to replace the belt. Otherwise, it may only need lubrication or waxing to keep it functional.

If one or two signs of damages are present, you may have to replace your belt. If you do not have the instruction manual, here are the basic instructions.

Removing the belt

- Unplug the treadmill. Make sure your treadmill is not connected to a power supply.

- Locate the hood of the treadmill's motor and remove it.

- Loosen and remove the screws on both sides to take out the rear roller. These are the same screws affecting the tension of the belt.

- The front roller can be removed using the same process. Incline the board if the screws are not accessible.

- Take out the front and rear rollers once the screws are removed.

- Take the belt out.

Replacing the belt for treadmill

- Lay the new belt and deck together. Slide the belt over the deck and align.

- Install the rollers and fasten the deck to the frame properly and securely.

- The next step is to fasten the belt and deck together with the screws. You may need to adjust the deck to get the screws in.

- Slide the belt in through the rear roller by pulling it to the rear end.

- Tighten the screws a bit to hold the parts together.

- Replace the drive motor belt over the drive gear by sliding the front roller inside the belt.

- Fix the belt snuggly onto the deck by tightening the screws on the front and rear rollers.

- Adjust the belt. The adjustment concept is done by changing the speed to test the tightness and feel of your belt.

The procedure is actually simple but if you haven't done this before, it's best not to do it yourself. Seek help from someone who has more experience in replacing a belt for treadmill.