Step A:



Prepare by gathering all of your items that you are going to need. Make sure your surrounding area is protected against any possible over spray. Any parts that do not need to be sprayed and that can be removed then do so. For other areas cover well with paper and masking tape.

Step B:

You will have to examine the car carefully for any rough spots. These will need to be sanded with 300 grit sand paper. This will smooth out the rough spots. It also allows the spray car paint to adhere better. Once you have finished sanding, make sure all of the dust dirt and debris are removed from the vehicle. It's imperative that the car be perfectly clean.

Step C:

You will need to apply a primer. This will make sure that you get an overall even coat of your colored paint plus helps the paint to adhere well. When you spray the primer, make sure you apply light coats and allow for drying in between. How to spray car paint takes a little getting used to.

Step D:

Now you are pretty well to the point where you are about ready to spray the color. You may have decided to use the spray car paint that comes in aerosol cans, or perhaps you have opted for the spray gun. In either case, make a few practice strokes on an object before you start with the car. Once you are ready, start the passes with the paint without hesitation. If you hold the spray can or gun in one spot, you will end up with uneven coverage and possibly the paint will run. If this happens you have a major repair job on your had. You will most likely have instructions as to how to spray car paint using the equipment or spray cans.

Step E:

It's up to you whether you want to wet sand between coats of primer and color paints. You may want to research this option on the web, or check with someone that is familiar with how to spray car paint

Step F:

Once you are totally satisfied with the color, you are down to the finishing touches. You will now want to apply several clear coats. This will give the gloss and finished look to the car as well as protect the finish. Probably two coats will be sufficient but it will be up to you. Make absolutely sure it is dry in between coats.

Step G:

Once again, you have the option of wet sanding if you prefer. Again, I suggest you ask the advice of individuals that are familiar with how to spray paint a car. If you decide to follow this step then you need to wet sand with the following grits in this order. Use 800, 1000, 1200, 1500 and the finally the 2000. This will remove spots that may be too heavy in the clear coat application.

Step H:

Now you will want to using a rubbing compound to buff the surface so you can use a 2000 grit to remove any scratches.

Step I:

You should now buff the surface. To do this simply use a medium cut polish. Once you have done this, you should have a perfect glassy look to the finish.

Step J:

As a final touch, you may want to apply a few coats of wax.