Installing a Transmission Cooler

Begin:

To install a transmission cooler you will need only simple hand tools and the cooler itself. There are a number of them out there but one several of us have used fits nicely and works well. It's a B&M 19,000 GVW unit and you can purchase it at many speed shops or through mail order from Jegs or Summit Racing.

Most of the kits supply the fittings, however you may have to adapt the fittings to your needs. Most of the supplied fittings are 5/16" fittings, but on the GP you'll need 5/8" fittings. Take care of this adaptation in advance or you won't be driving the vehicle anywhere.

Optional: When installing the cooler, some believe it is also good to switch to synthetic fluid and change the filter. Some of us use Red Line ATF (Dexron III equivalent) for this purpose. It is supposed to keep your transmission cooler and operating better than standard fluid, but will run you about $8 per quart (and you'll need 8 or 9 quarts) so it can be a bit expensive. Since you'll have the car up anyway, this is a good time to do this upgrade. See the Helm's manual for more details on changing the fluid.

You will need to jack the front end up or put it up on ramps. Either way, make sure it is secure. You will be crawling under it, and you definitely don't want your GP to fall on you! Make sure it's nice and high so you can work comfortably.

To begin, remove the lower air dam at the base of the radiator. This is held on with about 6-8 bolts that are right on the bottom and easy to see.

Decide which location you would like to use to tap into the fluid lines. They run from the to the right (passenger) side of the radiator. The return line runs from the top of the radiator to the pan and the supply runs from the transmission housing to bottom of the radiator. The bottom of the transmission has the two lines coming out from it.

It is normally preferable to have the external cooler plumbed in series with the return line. This provides the most efficient cooling by about 5%. However, the port at the top of the radiator where the return line exits is kind of a tight squeeze to work with, so you can tap into it at the transmission but this requires running longer fluid lines back to the radiator area (some of us have done this with no problems). If you plan to do this, you may tap directly into the existing connection near the radiator as shown in the following photo (click for larger view). In the photo, notice that I cut off the existing hose and attached the hose to be connected to the cooler instead.

Alternatively, plumb into the supply line. It has slightly less cooling efficiency but simplifies the installation a little bit (no picture available).

Remove the appropriate lines and hook up the fittings. Be sure to seal any non-flare fittings or they might leak.

Mount the cooler low on the front of the radiator using the supplied fasteners.

Run the lines from the fittings to the cooler. Be sure the are not hanging down or rubbing on an edge surface.

Before you install the air dam, you might need to trim it a bit to allow clearance for the lines. Re-install the air dam.

Crank it and allow pressure to build. Check for leaks at every point in the fluid flow. If there are leaks, shut off the vehicle and fix them. Otherwise take the car for a spin and heat up the fluid, (which should take about 10 minutes). Come back and check for leaks again, and repair if necessary.