If you are unfortunate enough to have to test your home for mold, you are probably thinking that this is going to be a pretty inconvenient thing to have to do. Well, it might not be fun to think that you have disease-causing mold living in your house, but doing the actual test to determine if it exists is not really that hard to conduct at all.

Whatever kind of test kit you end up using, the directions on the package must be followed to the exact letter or you will probably render the test useless. There are a few quite general rules that you should follow to get the most out of your testing kits.

If you can see the mold growing in your wall, ceilings, carpet, or on anything else in the home, you do not really have to do any guesswork as to whether you need to test the home or not. If you see anything like this, do not only test that room; test your entire home.

Every room needs to be tested and this includes the ventilation system, because it extends to every room in the house and if mold is growing in the vents, it will spread to the rest of the house. Run the air conditioner or fans in every room in your home before you put out the test kits so that if there are any mold spores in the room, they will be stirred up into the air and will settle down in the kit.

Do not set them up anywhere high; a coffee table or somewhere around the mid to low level of the room should be fine. If you set them up too high, you may not get a good sample.

If there happens to be mold growing visibly on anything, you can use a piece of scotch tape to lift the mold up off the surface and place it into the test kit. There is a method that you can use involving scraping some of the mold into the kit with a knife, but since this can stir up mold spores even more, unless you are wearing a respirator, you are probably better off using the tape method.

To test the ventilation system, the best thing that you can do is tape a test against the grill of one of the ventilation ducts so that the air coming out of it is hitting the testing kit at a 90 degree angle. This will allow you to get the maximum amount of exposure.